I decided to update and repost this topic since we have so many new quillers contacting us. How you roll your quilling strips is really a matter of
personal preference. I don’t believe there is a hard and fast rule, although many
quillers have very definite opinions about the subject.
Slotted tool-
When I first learned to quill, I learned using a slotted tool. You just
‘thread” the beginning of a strip into the slot and then turn the tool until
the strip is completely rolled. Let the strip fall off the tool and then pinch
into desired shape and glue. Depending on the slotted tool you use, there will
be a small opening in the center of your tight rolls (the size of the hole is
determined by the size of the shaft of the tool). There may also be a tiny fold
in the strip where you first inserted the strip into the tool. This little fold
or “hook” is offensive to some quillers. If this is a concern for you, the hook
can be eliminated by reversing the tool before releasing the roll. It can also
be eliminated when you pick up the roll with a tweezer.
Today we have a much wider selection of slotted tools with
different size shafts. We even have a battery operated tool. (
T33023)
The newest tool in our collection (
QCT323)
is one with a wide handle that doesn’t move in your hand. It rests in your palm
and you only turn the slotted part. This new tool makes a really small hole in
the center of the quill. Another “newer” tool is a double sided tool with a
very sharp needle on one end and a slot on the opposite end (
T26216)
Pin or Needle tool-I
know that many of the early “1970’s” kits came with a corsage pin. When you use
a pin or a needle, you roll the paper around the pin (instead of turning the
tool), the hole in the center will be smaller and there will be no hook.
Finger rolling-When
finger rolling your strips, it helps to soften the paper a little by running it
over your finger nail, much like you would with curling ribbon. I usually have
a damp washcloth nearby and dampen my fingertips so it is a little easier to
get the roll started. Your finished roll will have a very tiny center
opening. I also find that my rolls are a
little “tighter” when I finger roll. After using a slotted tool for many years,
the repetitive motion began to bother my thumb, so I forced myself to learn to
finger roll. I quickly realized this was also easier on my tired old eyes since
I was no longer required to ‘thread’ my slotted tool. Now I finger roll most of
my strips but still use my slotted tools for rolling fringe flowers and curling
back the corners on my rose petals.
I do have a funny story about finger rolling. A few years ago I did a taping for the DIY
(Do It Yourself) network demonstrating quilling and how it can be used for
scrapbooking. I had to fly from Connecticut to
Tennessee for
the taping. With all of the security restrictions on the airlines I thought it
best to put all my quilling tools, tweezers and scissors etc. in my checked
luggage. Of course my bags were opened and inspected. The next day as I
prepared to do the taping, I opened the box with all of my tools and realized I
had no slotted tool! Thank goodness I knew how to finger roll! The DIY folks
were pretty impressed with my finger rolling although it was harder to tape. (I
was only allowed to move my fingers a tiny bit so the camera could zoom
in.) At any rate we got through the
taping and when I packed my bags to fly back home, there in the bottom of my
suitcase was my slotted tool! When they inspected the bag they just didn’t put
everything back where they found it. And I am sure they had no idea what they
were looking at.
Posts
